Home > LED Intermediate Bulbs > LED Bulbs, #3157; #3156 Wedge-Based LED Automotive Lamps > 0.625-in. Wedge Base Automotive Lamps
White LED technology is patent protected in the US. LEDtronics White LED products are covered under these patents.
Patent No. US 6,598,996,B1 Note: LED brake/tail lamps may not work with some older thermal flasher units. An LED brake/tail lamp will require an electronic flasher/blinker unit which is commonly available at your local auto parts store. Note: Wedge base bulbs are polarity sensitive. If LED bulb fails to light, remove bulb, turn it 180º, and re-insert.
All Series under this Category:
AUT3156 3156 Wedge Base Bulb AUT3157 3157 Wedge Base Bulb AUT-RES Load Resistor
Back-Up Light
Electrical-Optical Characteristics (Ta = 25°C)
Brake Light, or Turn Signal, or Running Light
Electrical-Optical Characteristics (Ta = 25°C)
Turn Signal, or Running Light
Electrical-Optical Characteristics (Ta = 25°C)
‡‡Full Beam Width at 50% Intensity
Brake / Turn / Tail Light
Electrical-Optical Characteristics (Ta = 25°C)
Turn / Running Light
Electrical-Optical Characteristics (Ta = 25°C)
‡‡Full Beam Width at 50% Intensity
Load Resistor Statement: If installing LED bulbs in your car or motorcycle causes your blinkers to blink fast or causes other electrical problems you may need to install a load resistor to correct these problems. Since LED bulbs draw much less current than standard incandescent bulbs your electrical computer system may think that your bulbs are not working. The AUT-RES-6-50 should resolve these problems. This is a 6 Ohms 50 Watt resistor that needs to be installed in-parallel with your tail/blinker lights, one Load resistor (AUT-RES-6-50) is required for each tail/blinker light.
Load Resistor
Electrical-Optical Characteristics (Ta = 25°C)
Caution: This Load Resistor (AUT-RES-6-50) gets extremely hot and needs to be installed correctly. The flat surface of the AUT-RES-6-50 needs to make a good secure contact on a clean flat metal surface on your car or motorcycle. This will act as a heat sink which should keep the Load Resistor (AUT-RES-6-50) cooler. Keep this Load Resistor (AUT-RES-6-50) away from oil, skin, plastic, wires , combustible gases and flammable materials. LEDtronics is not responsible for damage caused to persons or property with installation of the Load Resistor (AUT-RES-6-50).
Prop. 65 Warning WARNING: This product can expose you to chemicals including Di(2-ethylhexl)pthalate (DEHP), which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov All specifications and pricing subject to change without notice.
|